Digi IX14, Руководство пользователя

Страница: 435 / 828

Containers Configure a container
IX14 User Guide 435
New containers are enabled by default. To disable, or to enable a container if it has been
disabled, click
Enable .
5. Clone DAL is enabled by default. This allows the container to use the device's system libraries.
6. Enable Virtual Network if the container should have network access:
a. Select a Network Bridge Device that will provide access to the container.
b. (Optional) Enter a static IP Address and netmask for the container. This must be a valid IP
address for the bridge, or, if left blank, a DHCP server can assign the container an IP
address.
c. (Optional) For Gateway , type the IP address of the network gateway.
7. Click to expand Serial ports to sssign serial ports that the container will have access to.
a. For Add Port , click

.
b. For Port , select the serial port.
8. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new container:
(config)> add system container name
(config system container name )>
where name is the
New access points are enabled by default.
4. New containers are enabled by default. To disable:
(config system container name )> enable false
(config system container name )>