Digi IX14, Руководство пользователя

Страница: 123 / 828

Interfaces Local Area Networks (LANs)
IX14 User Guide 123
a. Click to expand IPv6 .
b. Enable IPv6 support.
c. For Type , select IPv6 prefix delegration .
d. For Prefix length , type the minimum length of the prefix to assign to this LAN. If the
minimum length is not available, then a longer prefix will be used.
e. For Prefix ID , type the identifier used to extend the prefix to the assigned length. Leave
blank to use a random identifier.
f. Set the MTU .
12. (Optional) Click to expand MAC address denylist .
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address denylist .
a. Click to expand MAC address denylist .
b. For Add MAC address , click

.
c. Type the MAC address .
13. (Optional) Click to expand MAC address allowlist .
If allowlist entries are specified, incoming packets will only be accepted from the listed MAC
addresses.
a. Click to expand MAC address allowlist .
b. For Add MAC address , click

.
c. Type the MAC address .
14. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new LAN or edit an existing one:
n
To create a new LAN named my_lan :
(config)> add network interface my_lan
(config network interface my_lan)>
n
To edit an existing LAN named my_lan , change to the my_lan node in the configuration
schema: