Digi IX14, Руководство пользователя

Страница: 714 / 828

Routing IP routing
IX14 User Guide 714
n
Interface : Matches the destination IP address to the selected interface's network
address.
n
IPv4 address : Matches the destination IP address to the specified IP address or
network. Use the format IPv4_address /[ netmask ], or use any to match any IPv4
address.
n
IPv6 address : Matches the destination IP address to the specified IP address or
network. Use the format IPv6_address /[ prefix_length ], or use any to match any IPv6
address.
n
Domain : Matches the destination IP address to the specified domain names. To
specify domains:
i. Click to expand Domains .
ii. Click the

to add a domain.
iii. For Domain , type the domain name.
iv. Repeat to add additional domains.
n
Default route : Matches packets destined for the default route, excluding routes for
local networks.
13. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX14 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a new routing policy:
(config)> add network route policy end
(config network route policy 0)>
New route policies are enabled by default. To disable:
(config network route policy 0)> enable false
(config network route policy 0)>
4. (Optional) Set the label that will be used to identify this route policy:
(config network route policy 0)> label "New route policy"
(config network route policy 0)>