CAUTION:
Do not attempt to remove the TPM plug-in module from the system board. After the TPM plug-in module is
installed, it is cryptographically bound to that specific system board. Any attempt to remove an installed TPM plug-in
module breaks the cryptographic binding, and it cannot be re-installed or installed on another system board.
1. Follow the safety guidelines listed in Safety instructions section.
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in
Before working inside your system
on page 52.
4. Remove the following components:
a. cooling shroud
b. memory modules
c. cooling fan
d. expansion cards
e. heat sink and processor
f. iDRAC port card, if installed
g. internal dual SD module, if installed
Steps
1. Disconnect all cables from the system board.
CAUTION:
Take care not to damage the system identification button while removing the system board from the
chassis.
2. Remove the screws on the system board, and slide the system board toward the front of the chassis.
3. Hold the system board by the touch points and lift it out of the chassis.
CAUTION:
To prevent damage to the system board, do not lift the system board by holding a memory module,
processor, or other components; hold the system board by its edges only.
Figure 90. Removing the screws on the system board
a. screw (8)
Installing and removing system components
135
Содержание E35S001
Страница 2: ......
Страница 164: ...164 Getting help ...
