Dell E35S001, Руководство пользователя

Страница: 137 / 164

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be performed only by Dell
certified service technicians.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identification button while placing the system board into the chassis.
1. Follow the safety guidelines listed in Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #2 screwdriver ready.
Steps
1. Hold the system board by its edges, and orient it toward the back of the chassis.
2. Lower the system board into the chassis until the connectors at the back of the system board align with the slots on the back of the
chassis.
3. Tighten the screws that secure the system board to the chassis.
Figure 92. Install the system board
a. system board
b. touch point (2)
c. system board t-handle post
Next steps
1. If required, install the Trusted Platform Module (TPM). See, the Installing the Trusted Platform Module section.
2. Reinstall the following components:
a. expansion cards
b. memory modules
c. heat sink and processor
d. cooling fan
Installing and removing system components 137