Dell E35S001, Руководство пользователя

Страница: 134 / 164

Figure 89. Installing the optional VGA module
1. VGA module 2. control panel
3. hook (2) 4. VGA connector on the control panel board
Next steps
1. Install the control panel assembly cover.
2. Install the control panel assembly.
3. Follow the procedure listed in the After working inside your system section.
Related tasks
Installing the control panel assembly cover on page 127
Installing the control panel assembly on page 126
Preparing a system for conversion from tower mode to rack mode on page 143
System board
A system board (also known as the motherboard) is the main printed circuit board in the system with different connectors used to
connect different components or peripherals of the system. A system board provides the electrical connections to the components in the
system to communicate.
Removing the system board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow
the safety instructions that are shipped with your product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be performed only by Dell
certified service technicians.
CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may be prompted to create a
recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this
system board, you must supply the recovery key when you restart your system or program before you can access the
encrypted data on your hard drives.
134 Installing and removing system components