Cumberland EDGE 890-00601, Инструкция по установке и эксплуатации

Страница: 85 / 258

10
House/barn setup
Topics Covered in this Chapter
▪ Assigning sensors to equipment and for a house/barn temperature average
▪ Alarm Setup
▪ House/barn and room temperature setup
▪ Relative humidity setup
▪ Static pressure setup
▪ Cooling setup
▪ Heater setup
▪ Brooder setup
▪ Egg room setup
▪ Light setup
▪ Power ventilation setup
▪ Natural ventilation setup
▪ Tunnel ventilation setup
▪ Auger setup
▪ Bird scale weighing platform setup
▪ Time clock setup
▪ Power ventilation grid
▪ Natural ventilation grid
▪ Tunnel ventilation grid
▪ Stir fans in the ventilation grid
▪ Configuring sidewall or pit fans for Tunnel ventilation
Assigning sensors to equipment and for a house/barn temperature
average
Sensor assignation is performed after equipment configuration and before any other type of setup.
1. Press on the icon, and then select Probe assignment at the bottom of the screen
2. Press on the equipment displayed on the left hand side of the screen to assign sensors to the equip-
ment. Your choices are as follows:
• House/barn temperature— takes an average reading of all selected sensors to give the house/
barn temperature average in different ventilation modes
• Cooling— assign sensors to the cooling equipment
• Heating— assign sensors to the heating equipment
• Brooding— assign sensors to the brooding equipment
• Inlets— assign sensors to the inlets
3. Put a check mark by pressing in the box to select the sensor.
895-00693 EDGE 85