Cumberland EDGE 890-00601, Инструкция по установке и эксплуатации

Страница: 9 / 258

Chapter 1: Introduction
Safety messages
DANGER
Turn off the main electrical disconnect switch prior to servicing any of the boxes.
Failure to do so might lead to serious injury or death.
Always use extreme caution when measuring voltage or performing procedures that require a
module to be powered on.
Electrostatic discharge prevention when manipulating a printed circuit board
(PCB)
Electrostatic discharge (ESD) can damage equipment and impair electrical circuitry. ESD damage occurs
when electronic components are improperly handled and can result in complete or intermittent failures.
Always follow ESD on a PCB-prevention procedures when you remove and replace components. Ensure
that the chassis is electrically connected to earth ground. Wear an ESD-preventive wrist strap, ensuring
that it makes good skin contact. Connect the grounding clip to an unpainted surface of the chassis frame
to safely ground unwanted ESD voltages. To guard against ESD damage and shocks, the wrist strap and
cord must operate properly. If no wrist strap is available, ground yourself by touching the metal part of the
chassis.
For safety, periodically check the resistance value of the antistatic strap, which should be between 1 and
10 megohm (Mohm).
Terms of use
Read and follow all installation, operation, and maintenance information carefully before using the prod-
uct. Refer to the user documentation for complete product specifications. If the product is used in a
manner not specified, the protection provided by the product warranty will be void.
Using the product according to your function
A responsible body is an individual or group responsible for the use and maintenance of equipment, for
ensuring that the equipment is operated within its specifications and operating limits, and for ensuring
that operators are adequately trained.
Operators use the product for its intended function.
Maintenance personnel perform routine procedures on the product to keep it operating properly
Service personnel are trained to work on live circuits, perform safe installations, and repair products. Only
properly trained service personnel may perform installation and service procedures.
General safety usage
Follow the guidelines given below for safe usage of the product:
• Installation must only be performed by qualified service personnel
• Carefully read all instructions
• Comply with local and national safety codes
• Repairs must only be performed by qualified service personnel
• When replacing the fuses, use only the same type and same rating as specified
• Make sure the unit is disconnected from AC power when servicing
895-00693 EDGE 9