Cumberland EDGE 890-00601, Инструкция по установке и эксплуатации

Страница: 91 / 258

Chapter 10: House/barn setup
Table 10-4 with fixed absolute house/barn start temperature (cont'd.)
Stop temperature offset Offset from start temperature at which a cooling device stops
Efffective stop
temperature Calculated stop temperature = effective start tempe stop temperature offset
Maximum On time Operating time when temperature read by assigned probes is equal or less than the
Effective start temperature
Cycle time Operating cycle time when temperature read by assigned probes is within operating
temperature range
Time of day - check box Limits cool cell operation to a certain time slot each day
Time of day - Start Time of day at which cool cell operation may begin
Time of day - Stop Time of day at which cool operation must stop
Max RH - Check box Stops cool cell operation when house/barn relative humidity gets higher than Max
RH
NOTE: This box is grey (not pressable) when there there is no configured relative
humidity probe in the house/barn.
Max RH - RH House/barn relative humidity threshold at which cool cell stop when this option is
used
Minimum animal age -
check box Prohibits cool cell operation when animals are younger than minimum animal age
Minimum animal age - age Minimum animal age required to allow cool cell operation when this option is used
Minimum outside tempera-
ture - check box Prohibits cool cell operation when outside temperature is lower than minimum.
Minimum outside tempera-
ture - temperature Minimum outside temperature required to allow cool cell operation when this option
is used
NOTE: This box is grey when (not pressable) when there is not at least one config-
ured external temperature probe
Table 10-5 with fixed offset on house/barn temperature set point start temperature
Set point Actual house/barn temperature set point, changes frequently
Table 10-6 with variable offset on house/barn temperature set point start temperature
Selects the animal vs cooling start temperature offset curve from a list of available
cooling curves
Age Actual age of animals, which gives the actual cooling start temperature offset on
actual house/barn temperature set point.
Heater setup
Heating equipment is divided into 3 categories. Settings can be based on a fixed temperature or fixed
offset on the house/barn temperature set point as control parameters.
Single capacity heaters
There are two ways to setup control temperatures on single capacity heaters. You can use a fixed temper-
ature or fixed offset.
895-00693 EDGE 91