COSMOGAS Adveco MYDENS 15B, Инструкция по установке, использованию и техническому обслуживанию

Страница: 57 / 96

57
MYDENS
COSMOGAS
7 - USE
7.16 - Access and setting of the
installer profile
a
WARNING!!! Changing these parameters could
cause appliance and therefore system malfunctions.
For this reason, only a technician that has an in-
depth knowledge of the appliances can modify them.
To analyse the operation and adaptation of the appliance
to the system, the technician has access to the parameters
below via the “Installer profile”.
To access, proceed as follows:
1. - Press the RESET button;
2. - The display shows parameter
0.000
;
3. - Press the button up to the parameter
Code
;
4. - Press the RESET button;
5. - Type the code
0300
in the following way:
A - The display shows
0---
;
B - Press the RESET key to confirm the
0
and move
on to the next number;
C - Press the key until it appears
3
;
D - Press the RESET key to confirm the
3
and move
on to the next number;
E - Press the RESET key to confirm the
0
and move
on to the next number;
F - Press the RESET key to confirm
0
by completing
the access code;
6. - Scroll through the parameters using the keys
and ;
7. - To access the parameters, press the RESET key;
8. - To modify the parameters, press the keys
and
;
9. - To confirm the changes to the parameters, press the
RESET key;
10. - To exit the installer profile, press the button ;
If no button is pressed for more than 5 minutes, the installer
profile is automatically exited;
a
WARNING!!! Any variations made to the
parameters must be noted in the “Customised
values” column in the following table, in order to
facilitate any future replacements of the control
board.
The following parameters can be changed or examined in
this profile:
Parameter Description of the parameter
Access
level
U.M. Range
Factory
value
Customised
values
2001 Central heating mode Installer # 0 = Constant temperature with
RT;
1 = Outdoor reset with RT;
2 = Outdoor reset with RT
influence;
3 = Constant temperature with RT
influence;
4 = Control input 0-10 V with RT;
5 = N/A;
0
2003 Desired heating temperature Installer °C 30...80 60
2005 Heating post-circulation pump Installer Sec 0...900 120
2006 Maximum flue gas temperature Factory °C 10...120 95
2007 Heating positive hysteresis Factory °C 0...20 5
2009 Delay against frequent burner ignition Installer Sec 10...900 180
2010 Temperature differential against frequent burner
ignition
Installer °C 0...20 16
2012 Maximum differential heat exchanger temperature Factory °C 10...80 30