COSMOGAS Adveco MYDENS 15B, Инструкция по установке, использованию и техническому обслуживанию

Страница: 37 / 96

37
MYDENS
COSMOGAS
5 - INSTALLATION
5.17.9 - “80PP single” system
(polypropylene) (Type "B23" or "B23P")
a
WARNING!!! If the appliance is installed
with a B23 or B23P exhaust, it will take in air for
combustion from the surrounding environment.
Therefore, all precautions must be taken regarding
ventilation of the rooms as prescribed by the
national and/or local regulations.
l
Read and follow the precautions set out in section
5.17.1.
The appliance is supplied as per standard without fittings to
connect the flue exhaust/air intake.
To connect the appliance to a “80PP single” system, the
relevant kit must be requested and must be installed as in
Figure 37.
l
Take particular care with the installation of ducts
in the part that passes through the wall to the outside;
the normal maintenance operations must always be
possible, therefore, install the pipes in a sheath so that
they can be slid out.
l
The horizontal tracts must always have an inclination
of at least 2% towards the condensate drain device.
l
The appliance is already set up with a condensate
collector, which must be fitted to a drain pipe (see section
5.9).
a
WARNING!!! This condensate drain is designed
to drain away all of the liquid produced by a single
appliance. If more than one appliance is installed,
each appliances should be provided with its own
condensate drain.
The flue exhaust/air intake system can be extended up to
a maximum distance as indicated in section 9. Every 90°
bend has a loss equivalent to the value in section 9. Every
45° bend has a loss equivalent to the value in section 9.
a
WARNING!!! The flue exhaust terminal must be
appropriately protected against the effects of the
wind (see also section 7.17.1
Loc 22
).
a
WARNING!!! Mechanically secure the joints
between the various component elements of the
exhaust and intake ducts, through the use of fixing
systems or equivalent systems (Figure 28).
a
WARNING!!! The temperature of the exhaust
pipe can reach 90°C during operation. If the pipe
passes through walls that are sensitive to these
temperatures, insert a protective heat-insulating
sheath.
a
WARNING!!! The exhaust and intake ducts
must be appropriately sustained via rigid brackets
positioned no more than 1 metre from each other.
The brackets must be fixed to rigid walls that can
support the weight of the pipe itself.
5.17.10 - “80PP Single” system:
accessories available
To set up this system, are available, on request, the
accessories written in section 5.17.3.
A
B
D
C
E
A
B
C
E
62403659_021
Figure 37
Figure 38