COSMOGAS Adveco MYDENS 15B, Инструкция по установке, использованию и техническому обслуживанию

Страница: 18 / 96

18
MYDENS COSMOGAS
5 - INSTALLATION
5.8 - Wall mounting
Figure 12
a
WARNING!!! The wall bracket screws must be
screwed into the buildings framing or other material
capable of supporting the weight of the appliance or
the appliance and building may be damaged causing
severe personal injury or substantial property
damage.
1. - Mark the screw holes for the wall bracket "A";
2. - Install wall bracket "A" using screws "E";
3. - Hang the appliance on the wall bracket “A”, by hanging
connections “B” and “C” on tabs “D”;
5.9 - Condensate drain pipe
In the appliance there is a siphon for the evacuation of
condensate,to prevent combustion products from escaping
and it is equipped with a conduit "F".
F
020002.01.017
Figure 13
a
WARNING!!! This terminal must be conveyed into
another anti-odour siphon (Figure 14 detail “G”) to
prevent bad odours in the environment (the anti-
odour siphon “G” is supplied on request).
a
WARNING!!! For residential rooms and office
rooms with more than 10 users, it is not necessary
to neutralize the condensation. If the room used
for office purposes has fewer than 10 users, before
up the domestic waste drain, install a condensate
neutraliser (see section 9 for the acidity value of the
condensate and the quantities).
a
WARNING!!! The condensate drain system must
be performed with a pipe with an internal diameter
equal to or greater than 13 mm.
a
WARNING!!! The condensate drain system must
bee installed in such a way as to prevent the liquid
from freezing, therefore pay attention to any external
sections.
d
It is prohibited to drain into gutters or rainwater
drainpipes.
a
WARNING!!! The condensate drain system must
slope continuously towards the drain point; avoid
high points, which could pressurise the pipe.