COSMOGAS Adveco MYDENS 15B, Инструкция по установке, использованию и техническому обслуживанию

Страница: 44 / 96

44
MYDENS COSMOGAS
6 - START-UP
6.8 - Adjusting the power in central
heating mode (Range Rated)
To optimize the seasonal performance of your system,
it is recommended to adjust the maximum power of the
appliance to the actual need of the system, using the
"Range Rated" functionality. To do this, proceed as follows:
1. - Power up the appliance and open the gas supply;
2. - Switch on the appliance;
3. - Access the “installer” profile (section 7.16);
4. - Set parameter
2014
as shown in the table (Figure
49);
Power
necessary
(kW)
APPLIANCE MODEL
15 24 34
32 - - -
31 - - 94
29 - - 88
27 - - 82
25 - 98 76
23 - 89 70
21 - 80 64
19 - 71 58
17 - 62 52
15 - 53 46
13 44 44 40
11 35 35 34
9 26 26 28
7 17 17 22
5 8 8 16
Figure 49
6.9 - Adjusting the domestic hot water
flow rate
If the domestic hot water flow rate is too high, the appliance
may not be able to heat it to the desired temperature. To
adjust the flow rate to the appliance, proceed as follows:
1. - Power up the appliance and open the gas supply;
2. - Switch on the appliance;
3. - Adjust the temperature of the domestic hot water to
48°C-50°C;
4. - Open the hot water tap completely. In the case of a
single lever mixer tap, the position must be completely
on “HOT”;
5. - Wait 3 minutes for the temperature to stabilise;
6. - If the water temperature is too cold, the flow rate must
be reduced using selector “A” (Figure 50), until the
desired temperature is reached;
A
020002.01.016
Figure 50