Comtech EF Data CRS-500, Инструкция по установке и эксплуатации

Страница: 96 / 220

CRS-500 1:N Redundancy System
Revision 4
Cables and Connections 5–36 MN-CRS-500
5.5.4 CRS-500 1:N Redundancy System Power-up Sequence
The system is ready for operations ONLY AFTER you successfully power
ON all components and you configure the modems for 1:N redundant
operations. Further operational information is available in the following
chapters:
•
Chapter 6. CONFIGURE MODEMS for 1:N REDUNDANCY
•
Chapter 8. CSU FRONT PANEL OPERATION
•
Chapter 9. ETHERNET INTERFACE OPERATION (for SNMP,
Telnet, and HTTP (Web Server) operation)
•
Chapter 10. SERIAL INTERFACE OPERATION (for serial remote
control operation)
Once you make all cabling and power connections, you must power-up the CRS-500 1:N
Redundancy System in the order listed here. Do these steps:
1. CRS-280L IF SWITCH POWER: If the CRS-280L IF Switch is included in the setup, turn
both power switches ON.
If the CRS-280L is not used, skip this step and proceed to turn power
ON to all modems.
2. MODEM POWER: Turn the power switches ON for all modems.
3. MODEM CONFIGURATION: Configure all modems for 1:N redundant operations as
required per Chapter 6. CONFIGURE MODEMS for 1:N REDUNDANCY .
4. CRS-500 POWER: Turn both power switches (located on the rear panel on the CSU)
ON.