Comtech EF Data CRS-500, Инструкция по установке и эксплуатации

Страница: 218 / 220

CRS-500 1:N Redundancy System
Revision 4
Appendix C C–6 MN-CRS-500
C.2.3 Set Up Transceivers
Configure the modems first for EDMAC operation, setting up the Remote Control
Address (RCA) for local units, and ESA (EDMAC addresses) for EDMAC modems. A
transceiver's address will be set automatically by its controlling modem if
connected via the FSK link when the ODU enable is configured.
•
Local Transceiver 1 (linked to Modem m on the Switch):
o
First, set up the modem RCA, as described in Section C.2.2.
o
On the modem, key to Enable ODU. The modem automatically sets the transceiver
address:
Transceiver MCA = (Modem RCA) + 1.
•
Local Transceivers 1 & 2 (1:1 configuration, attached to Modem m on the Switch):
o
First, set up the modem RCA, as described in Section C.2.2.
o
On the online modem, key to Enable ODU . The modem automatically sets the
transceiver addresses:
MCA of Transceiver #1=(Modem RCA)+1
MCA of Transceiver #2=(Modem RCA)+2
•
Distant Transceiver 1 (standalone):
o
First, set up the modems, first, as described earlier in this section. .
o
On the modem, key to Enable ODU . The modem automatically sets the
transceiver address:
Transceiver MCA=(Master ESA)+4=(Slave ESA)+3
•
Distant Transceivers 1 & 2 (1:1 configuration):
o
First, set up the modem, as described earlier in this section.
o
On the modem, key to Enable ODU . The modem automatically sets the
transceiver addresses:
MCA of Transceiver #1 = (Master ESA) + 4
MCA of Transceiver #2 = (Master ESA) + 5
C.3 M&C Applications
The system is set up such that it may be communicated to by an M&C application, e.g., SatMac
or CMCS. In the SatMac application, go to the
Link Edit Mode screen to enter the Monitor &
Control Addresses (MCA).