Comtech EF Data CRS-500, Инструкция по установке и эксплуатации

Страница: 84 / 220

CRS-500 1:N Redundancy System
Revision 4
Cables and Connections 5–24 MN-CRS-500
5.3.2.4 CRS-500

CDM-750/760 Traffic Data Cable Connections
5.3.2.4.1 10/100/1000 Gigabit Ethernet (GbE) Traffic Data Cable
Connections
1. Make sure that the modem CONFIG: REMOTE CONTROL > Inband (Inband Modem
Control) is disabled.
2. The Redundant Modem

DSU RMI and DSU TMI

Traffic Modem CA-0000069 control
cable connections should have already been made, as directed in Section 5.3.2.2 .
3. The Redundant Modem

DSU RMI and DSU TMI

Traffic Modem PP/CAT5FF7FTGY
Ethernet Comm cable connections should have already been made, as directed in
Section 5.3.2.3.1 .
4. The Redundant Modem RJ-45 port labeled “J4 | MGMT” is always connected to the
installed CRS-505 RMI Ethernet port labeled “Port 1.” Do not use the “J4 | MGMT” port
for any GbE traffic data connections.
5. Modem RJ-45 ports labeled “J5 | DATA” and “J6 | DATA” are intended for use as the
GbE traffic data connections.
See Figure 5-10. Do these steps:
1. For the Redundant Modem, connect PP/CAT5FF7FTGY cable(s) between the
Redundant Modem and the CRS-505 RMI:
a. Redundant Modem RJ-45 port labeled “J5 |DATA” or “J6 | DATA” to
b. CRS-505 RMI RJ-45 port labeled “Port 2” through “Port 4”.
2. For each Traffic Modem, connect PP/CAT5FF7FTGY cable(s) between each CRS-516
TMI and its respective Traffic Modem:
a. CRS-516 TMI RJ-45 port labeled “Port 2” through “Port 4” to
b. Traffic Modem RJ-45 port labeled “J5 |DATA” or “J6 | DATA”.