Comtech EF Data CRS-500, Инструкция по установке и эксплуатации

Страница: 165 / 220

CRS-500 1:N Redundancy System
Revision 4
Serial Interface Operation 10–1 MN-CRS-500
Chapter 10. SERIAL INTERFACE OPERATION
10.1 Overview
See Section B.3.1.1 in Appendix B. CONTROLLER / TMI CONNECTORS AND PINOUTS for the EIA-232/485 Interface
connector pinout table.
Serial remote product management of Comtech EF Data’s CRS-500 1:N Redundancy System is available using the ‘ P1 | Remote
Control ’ DB-9M port located on the CSU rear panel CRS-530 System Controller Module. This chapter summarizes key parameters and
procedures and their associated remote commands and queries, and provides detailed instructions for use of the serial remote interface.
Before you proceed with serial remote product management, make sure the following is true:
•
Your CRS-500 and its Redundant and Traffic Modems are interconnected and are operating with the latest
version firmware files.
•
You are using a Windows-based PC (user-provided) that is connected to the CRS-500 as follows:
o
The User PC serial port is connected with a user-supplied serial cable to the ‘P1 | Remote Control’ DB-9M
port located on the CSU rear panel CRS-530 System Controller Module.
o
The User PC Ethernet port is connected via a user-supplied hub, switch, or direct Ethernet CAT5 cable
connection to the CRS-500.
o
The User PC is running a terminal emulation program (for operation of the CRS-500 Serial or Telnet
Interface) and a compatible Web browser (for operation of the CRS-500 HTTP (Web Server) Interface).
o
The CRS-5000 Management IP Address has been noted using the CRS-500 Serial Interface or HTTP Interface.