Comtech EF Data CRS-500, Инструкция по установке и эксплуатации

Страница: 126 / 220

CRS-500 1:N Redundancy System
Revision 4
CSU Front Panel Operation 8–8 MN-CRS-500
8.2.1 Main SELECT (Top-Level) Menu
SELECT: Config Info
Status Utility
Use the
◄ ► arrow keys to select
Config , Info , Status, or Utility. Press ENTER . The function of
each menu branch and its pertinent chapter section are as follows:
•
Config (Configuration) Menu Branch – These screens allow you to fully configure
Switch operations. See Section 8.2.1 .
•
Info Menu Branch – These screens allow you to view summary Switch operations
information, without requiring you to access the nested Configuration screens. See
Section 8.2.2 .
•
Status Menu Branch – These screens allow you to monitor the status of the Switch and
to view the log of stored events for both the Switch and its attached modems. See
Section 8.2.3 .
•
Utility Men u Branch – These screens allow you to perform miscellaneous functions such
as setting the Real-time clock, adjusting the display brightness, etc. See Section 8.2.4 .
8.2.2 (SELECT:) Config (Configuration) Menu Branch
The switch may be monitored over the remote control bus at any time. When in
Local Mode, however, configuration parameters may only be changed through
the CSU front panel. Conversely, when in Remote Mode, the unit may be
monitored from the front panel, but configuration parameters may only be
changed via the remote control bus.
CONFIG: Op-Mode Manual
IP Remote Options
Use the
◄ ► arrow keys to select
Op-Mode , Manual , IP , Remote , or Options , and then press
ENTER .
8.2.2.1 CONFIG: Op-Mode (Operational Mode)
Operational Mode: M:N
Switching-Mode Active
Use this menu to enable or disable switching of the Traffic Modems. Use the
◄ ►
arrow keys to
select M:N , Switching-Mode , or Active. Press ENTER.