Cisco ONS 15310-MA SDH, Руководство по процедурам

Страница: 481 / 632

17-75
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 17 DLPs H100 to H199
Figure 17-5 Viewing the Rolls Tab
Step 12 If you selected Manual in Step 5 , click the rolled facility on the Rolls tab and then click Complete . If
you selected Auto, continue with Step 13 .
Step 13
For both Manual and Auto rolls, click Finish to complete the circuit roll process. The roll clears from
the Rolls tab and the rolled circuit now appears on the Circuits tab in the DISCOVERED status.
Step 14 Return to your originating procedure (NTP).
DLP-H184 Roll One Cross-Connect from an Optical Circuit to a Second Optical
Circuit
Step 1
From the View menu, choose Go To Network View .
Step 2
Click the Circuits tab.
Step 3 Press Ctrl and click the two circuits that you want to use in the roll process.
The circuits must have a DISCOVERED status; in addition, they must be the same size and direction for
you to complete a roll. The planned Roll To circuit must not carry traffic.The Roll To facility should be
DCC connected to the source node of the Roll To circuit.
Step 4
From the Tools menu, choose Circuits > Roll Circuit .
Step 5
In the Roll Attributes area, complete the following:
a.
From the Circuit Roll Mode drop-down list, choose Auto to create an automatic roll (required for a
1-way source roll) or Manual to create a manual roll (required for 1-way destination roll).
Purpose This task reroutes a cross-connect on one circuit onto another circuit
resulting in a new destination.
Tools/Equipment None
Prerequisite Procedures DLP-H29 Log into CTC, page 16-43
DLP-H52 Provision Section DCC Terminations, page 16-68 for the ports
involved in the roll
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioning or higher