Cisco ONS 15310-MA SDH, Руководство по процедурам

Страница: 504 / 632

18-4
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 18 DLPs H200 to H299
Note Timers T1, T2, and T4 are not used if TARP PDUs Origination is not enabled.
Step 3
Click Apply .
Step 4
Return to your originating procedure (NTP).
DLP-H202 Add a Static TID to NSAP Entry to the TARP Data Cache
Step 1
In node view, click the Provisioning > OSI > TARP > Static TDC tabs.
Step 2 Click Add Static Entry .
Step 3
In the Add Static Entry dialog box, enter the following:
• TID—Enter the TID of the NE. (For ONS nodes, the TID is the Node Name parameter on the node
view Provisioning > General tab.)
•
NSAP—Enter the OSI NSAP address in the NSAP field or, if preferred, click Use Mask and enter
the address in the Masked NSAP Entry dialog box.
Step 4 Click OK to close the Masked NSAP Entry dialog box, if used, and then click OK to close the
Add Static Entry dialog box.
Step 5
Return to your originating procedure (NTP).
DLP-H203 Remove a Static TID to NSAP Entry from the TARP Data Cache
Purpose This task adds a static TID to NSAP entry to the TDC. The static entries are
required for NEs that do not support TARP and are similar to static routes.
For a specific TID, you must force a specific NSAP.
Tools/Equipment None
Prerequisite procedures DLP-H29 Log into CTC, page 16-43
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioner or higher
Purpose This task removes a static TID to NSAP entry from the Tarp Data Cache
(TDC).
Tools/Equipment None
Prerequisite procedures DLP-H29 Log into CTC, page 16-43
Required/As needed As needed
Onsite/Remote Onsite or remote
Security Level Provisioner or higher