Cisco ONS 15310-MA SDH, Руководство по процедурам

Страница: 523 / 632

18-23
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 18 DLPs H200 to H299
Step 4 Click Apply .
Step 5
Return to your originating procedure (NTP).
DLP-H225 Set Up SNMP for a GNE
Step 1
In node view, click the Provisioning > SNMP tabs.
Step 2
In the Trap Destinations area, click Create .
Step 3
On the Create SNMP Trap Destination dialog box, complete the following fields:
• Destination Node Address—Enter the IP address of your network management system (NMS).
•
Community—Enter the SNMP community name. (For more information about SNMP, refer to the
“SNMP” chapter in the
Cisco ONS 15310-MA SDH Reference Manual .)
Set OPR Setting the optical power received
establishes the received power level as
100 percent. If the receiver power
decreases, then the OPR percentage
decreases to reflect the loss in receiver
power. For example, if the receiver power
decreases by 3 dBm, the OPR decreases
50 percent. Click SET .
Types Sets the type of alert that occurs when a
threshold is crossed. To change the type
of threshold, choose one and click
Refresh .
•
TCA (threshold crossing alert)
• Alarm
Intervals Sets the time interval for collecting
parameter counts. To change the time
interval, choose the desired interval and
click
Refresh .
• 15 Min
•
1 Day
Purpose This procedure provisions simple network management protocol (SNMP)
parameters so that you can use SNMP network management software with
the ONS 15310-MA SDH.
Tools/Equipment None
Prerequisite Procedures DLP-H29 Log into CTC, page 16-43
Required/As Needed As needed
Onsite/Remote Onsite
Security Level Provisioning or higher
Table 18-1 Optics Thresholds Settings (continued)
Parameter Description Options