Cisco ONS 15310-MA SDH, Руководство по процедурам

Страница: 479 / 632

17-73
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 17 DLPs H100 to H199
Step 5
In the Roll Attributes area, complete the following:
a. From the Circuit Roll Mode drop-down list, choose Auto to create an automatic roll (required for a
1-way source roll) or Manual to create a manual roll (required for a 1-way destination roll).
b.
From the Circuit Roll Type drop-down list, choose Single to indicate that you want to roll one
cross-connect on the chosen circuit.
Step 6 Click Next .
Step 7
In the Pivot/Fixed Point 1 window, click the square in the graphic image that represents the facility that
you want to keep (
Figure 17-3 ).
This facility is the fixed location in the cross-connect involved in the roll process. The identifier appears
in the text box below the graphic image.
The facility that is not selected is the Roll From path. The
Roll From path is deleted after the roll is completed.
Figure 17-3 Selecting a Path
Step 8 Click Next .
Step 9
In the Select New End Point area, choose the Slot , Port , and VC high-order path from the drop-down
lists to select the Roll To facility ( Figure 17-4 ).