Cisco ONS 15200 Series, Инструкция по установке, настройке и эксплуатации

Страница: 25 / 136

2-5
Cisco ONS 15200 Installation, Setup, and Test Manual
78-13765-01
Chapter 2 Pre-Installation Procedures
Procedure: Unpack the ONS 15201 Single-Channel Units
Caution
When opening a subrack container, use caution to avoid damaging the contents.
Caution
Static electricity can damage electro-optical equipment. While unpacking and handling optical and
electrical modules, wear a grounding wrist strap to discharge the static buildup. Before unpacking
and installing modules or making system interconnections, connect the grounding wrist strap. The
grounding wrist strap is designed to prevent equipment damage caused by static electricity.
Step 1
Open the top of the cardboard shipping container.
Step 2 Take the box containing the ONS 15201 SCU accessory kit out of the shipping container.
Step 3
Lift the ONS 15201 SCU packaging box and strip the inserts away. Open the packaging box.
Step 4 Lift the SCU out of the packaging box and remove the plastic protective bag.
The ONS 15201 SCU shipping container should contain the following items:
• One SCU
•
Accessory kit, which includes rack mounting screws, disposable ESD wrist straps, power supply
units (2 pcs), power supply cables (2 pcs), a ground strip, an internal bus (CAN bus) extension cable,
and a documentation CD.
Procedure: Unpack the ONS 15200 Modules
Caution
When opening a module container, use caution to avoid damaging the contents.
Caution Static electricity can damage electro-optical equipment. While unpacking and handling optical and
electrical modules, wear a grounding wrist strap to discharge the static buildup. Each subrack is
equipped with grounding wrist strap connectors. Before unpacking and installing modules or making
system interconnections, connect the grounding wrist strap. The grounding wrist strap is designed to
prevent equipment damage caused by static electricity.
Step 1
Open the container and remove the module(s) and packing material.
Step 2
Carefully remove the protective foam packing material from the module(s).
Step 3 If any optical adapters are included in the container, remove them and save them for use while installing
the module front-panel optical fiber jumper cables (
Chapter 3, “Installation” ).