Cisco ONS 15200 Series, Инструкция по установке, настройке и эксплуатации

Страница: 111 / 136

5-3
Cisco ONS 15200 Installation, Setup, and Test Manual
78-13765-01
Chapter 5 Connectors and Cabling
Table 5-6 shows ONS 15201 SCU power supply connections.
5.2 Optical Fiber Jumper Cable Connectors
Note
Inspect and clean optical connectors prior to making optical connections. Unused optical connectors
should have plugs inserted.
5.2.1 ONS 15252 MCU Optical Connectors
Line module (LM) optical connections in the ONS 15252 MCU are listed in Table 5-7 . For specific
optical configurations, consult with your network planner.
4 CANH_RET CAN bus return (high) from MA system
5 CANH CAN bus (high) to MA system
6 CANL CAN bus (low) to MA system
7 TERM_INSER
T +4.5 VDC, 72ohms (Reserved, part of the CAN bus control)
8 NA Not used
Table 5-5 ONS 15201 Management Access Connections (continued)
Pin Number Function Signal
Table 5-6 ONS 15201 SCU Power Supply Connections
Connector Pin Number Voltage
PS-1 1 –48 VDC (–)
PS-1 2 –48 VDC (+) return
PS-1 3 –48 VDC (–)
PS-1 4 –48 VDC (+) return
PS-2 1 –48 VDC (–)
PS-2 2 –48 VDC (+) return
PS-2 3 –48 VDC (–)
PS-2 4 –48 VDC (+) return
Table 5-7 ONS 15252 LM Optical Connections
Connector Connection
Client IN (All CLIP modules) Client input signal (toward the ONS 15252 MCU)
Client OUT (All CLIP modules) Client output signal (from the ONS 15252 MCU)
A-side LM IN A-side DWDM input signal (toward the ONS 15252 MCU)
A-side LM OUT A-side DWDM output signal (from the ONS 15252 MCU)