Cisco ONS 15200 Series, Инструкция по установке, настройке и эксплуатации

Страница: 90 / 136

4-4
Cisco ONS 15200 Installation, Setup, and Test Manual
78-13765-01
Chapter 4 Turn Up and Test
f.
On the Properties dialog box, click the Settings tab and then click the ASCII Setup button.
g. On the ASCII Setup dialog box, check Send line ends with line feeds. Click OK until all dialog
boxes are closed. Leave the HyperTerminal window open.
Step 3
After you have connected the CIM RS-232 adapter cable ( Step 1 ) and set the parameters in Table 4-1 ,
press Enter in the HyperTerminal window. The system responds with a logon prompt. Press Enter
again. Because no password is needed, press Enter a third time.
Step 4
Create a user with administrator privileges:
a. At the NCB:> prompt, type
create user <user1>
and press Enter. The system responds:
Created
<user1>.
The user1:# prompt appears on the screen.
b. At the user1:# prompt, type
password <password1>
and press Enter to create a password for a new
user.
c. Type
privileges administrator
and press Enter to assign administrator privileges to the new user.
d. Type
exit
to return to the NCB:> prompt.
e.
At the NCB:> prompt, type
commit user <user1>
to finish adding a user with administrator
privileges.
Step 5
Create a user with operator privileges:
a. At the NCB:> prompt, type the command
create user <user2>
and press Enter. The system
responds:
Created <user2>
. The user2:# prompt appears on the screen.
b. Type
password <password2>
and press Enter to create a password for the new user.
c. Type
privileges operator
and press Enter to assign operator privileges to the new user.
d. Type
exit
to return to the NCB:> prompt.
e.
At the NCB:> prompt, type
commit user <user2>
to finish adding a user with operator privileges.
Step 6
Set the initial IP address of the NCB module:
a. At the NCB:> prompt, type
con sys
and press Enter.
b. At the NCB:= prompt, type
ipconf <ipaddr> <subnet> <gateway>
and press Enter.
Step 7 Reboot the system for the changes to take effect. At the NCB:= prompt, type
reboot
and press Enter.
Table 4-1 RS-232 Parameters
Parameter Value
Speed 19200 bps
Data bits 8
Parity None
Stop bits 1
Flow control None
ASCII Send EOL with
LF