Cisco ONS 15200 Series, Инструкция по установке, настройке и эксплуатации

Страница: 65 / 136

3-39
Cisco ONS 15200 Installation, Setup, and Test Manual
78-13765-01
Chapter 3 Installation
Figure 3-28 Side view of a CMY module
Step 5 Carefully insert the CMY. Be sure the groove on the back of the module interlocks with the crossbeam
in the passive optical shelf.
Step 6 Snap the CMY into place by pushing the retainer located at the bottom of the CMY front panel.
Step 7 Remove the dust plugs located on the CMY duplex adapter.
Step 8
Remove the fiber caps on the adjacent HFM.
Step 9
Clean, inspect, and insert the MU duplex connector from the adjacent HFM into the CMY.
Step 10 Fasten a fiber holder on the side of the passive optical shelf just outside the door.
Step 11 Guide the optical fiber cable from the CMY to the fiber holder and fasten the cable.
Step 12 Remove the dust plugs from the appropriate HFM in the second MCU.
Step 13 Remove the dust caps located on CMY optical fiber connectors.
Step 14
Clean, inspect, and insert the MU duplex connector from the CMY into the HFM in Step 12 .
Step 15
Fasten a fiber holder on the side of the passive optical shelf just outside the door of the second MCU.
Step 16 Guide the optical fiber cable from the CMY to the fiber holder and fasten the cable.
Procedure: Install the Dummy Filter Module in the ONS 15252 MCU
Step 1
Position the DFM in the passive optical shelf between the last A-side optical module and the last B-side
optical module.
Step 2 Slide the DFM into the passive optical shelf. Be sure the slot located on the back of the DFM aligns with
the crossbeam in the rear of the ONS 15252 MCU.
Step 3
Snap the DFM into place by pressing the retainer button located at the bottom front of the DFM.
Step 4 Repeat Step 1 – 3 until the passive optical shelf is filled ( Figure 3-29 ).
54906