Cisco ONS 15200 Series, Инструкция по установке, настройке и эксплуатации

Страница: 93 / 136

4-7
Cisco ONS 15200 Installation, Setup, and Test Manual
78-13765-01
Chapter 4 Turn Up and Test
Step 2 Compare the data in Table B-5 with data provided by the network planner, and verify that the data is
consistent. Complete Step 2 of Table B-4 .
Step 3 Compare the order of the Hub Filter modules (HFMs) on the A and B sides of the passive optical shelf
with those provided by the network planner and verify that the order is the same. Complete Step
3 of
Table B-4 .
Step 4 Check wavelength and output power:
a.
Connect a fiber from the A-side LM output port to a wavelength meter or an optical spectrum
analyzer (OSA) as shown in
Figure 4-2 .
b.
Set the wavelength range to a value between 1530 and 1560 nm. Record the wavelength and output
power in
Table B-6 on page B-3 .
c. Repeat on the B-side LM output port. Record the wavelength and output power in Table B-7 on
page B-4 .
Note Your network planner can provide the following values: expected output power, maximum, and
minimum. Actual transmit power on the LM OUT port must fall within the range provided by the
network planner.
27 192.7 1555.75
29 192.9 1554.13
31 193.1 1552.52
33 193.3 1550.92
35 193.5 1549.32
37 193.7 1547.72
43 194.3 1542.94
45 194.5 1541.35
47 194.7 1539.77
49 194.9 1538.19
51 195.1 1536.61
53 195.3 1535.04
55 195.5 1533.47
57 195.7 1531.90
Table 4-2 ONS 15200 Wavelength Plan (continued)
Channel Number Frequency (THz) Wavelength (nm)