Christie Roadie 25K, Руководство пользователя

Страница: 69 / 191

OPERATION
Roadie 25K User’s Manual
3-13
PIP (Picture-in-Picture)
NOTE: PIP performance may be limited by certain high frame rate sources.
Press the
PIP
toggle to enable or disable the Picture-in-Picture function in which
you can display two images at once – typically a smaller “secondary” image within a
large “primary” background. While you are using PIP, source image adjustments
such as location and resizing affect the secondary image only. To adjust the main
image instead, press
PIP
before the adjustment (for example, press
Gamma PIP
to change the gamma level of the main image). To remove the secondary
image from the display and return to a single image, press
PIP
while no menus or
slidebars are present.
Swap
Press
Swap
to swap the current picture-in-picture relationship so that the primary
image becomes secondary, and the secondary image becomes primary.
NOTES: 1) This key is available on the “brick” Rental/Staging remote only.
Alternatively, a swap can be accessed in the menu system. 2) Requires PIP.
Lens Focus, Zoom and Shift
Motorized lens controls are not available in this projector.
Backlighting
Press the “lightbulb” key to illuminate the keys on the remote without sending a
command to the projector.
Remote keypad operating settings (protocols)
The standard IR remote keypad stores an operating setting called protocol in
memory. In some applications, such as when you want to use multiple IR remotes to
control different projectors independently, you may want to override the default
keypad protocol set at manufacture (which is “A”) for one of the remotes. See 2.14
Remote Keypad Protocols and Conversion for complete instructions.
NOTE: In v1.1 software, only the IR protocol “A” is supported.
NOTE: This is a typical manual power-up procedure. Some installations may include
an automation system that controls projector start-up and lamp ignition in
conjunction with other variables such as lighting, audio and other equipment.
WARNING
Do not attempt operation if the AC supply
is not within the specified voltage range.
1. Make sure that ballast is properly configured for the AC at your site, and that it is
connected via 4 cables to the projection head. See 2.8, Connecting the Ballast.
2. Connect the heat extractor fan to the projection head. See 2.4, Installing a Lens,
Lamp & Cooling.
3. Connect the head to AC. The voltmeter on the back of the projector will indicate
the incoming level of AC, and the main
PROJ STATUS
light on the rear of the
PIP
Swap
Focus Zoom Shift
3.3 Power-up
Procedure /
Checklist
❏
❏
❏