Christie Roadie 25K, Руководство пользователя

Страница: 92 / 191

OPERATION
3-36
Roadie 25K User’s Manual
downloaded to the projector (requires separate PC-based Arbitrary Gamma and
KoRE Librarian software applications). If any special user curves have been
installed, their names will appear in the Gamma Table pull-down list.
Keep in mind that any Gamma Table choice sets the related Gamma value (shown in
the Image Settings menu) to a 2.5 default, where it can be fine-tuned as desired.
Different values (1-3) here indicate that the original gamma table has been adjusted
with either the Gamma slidebar or direct key.
SELECT COLOR ADJUSTMENT:
In “Select Color
Adjustment”, choose an overall color performance for all
images. The “Max Drives” factory default simply drives all 3
colors at their maximum level so that they are fully on and
cannot be changed. The two other pre-defined color
adjustment choices—SD Video and HD Video—apply a color
gamut optimized for video sources (standard or high-
definition). Alternatively, you can specify a color
temperature, which enables the nearby Color Temperature
slidebar and applies its current setting (default = 6500K). If none of the pre-defined
“Select Color Adjustment” options or color temperatures suit your application, select
one of four color gamuts previously defined by a user (User 1, 2, 3, 4). A “User”
option applies a customized color performance in which the user has precisely set the
hue and intensity of each color component in the Color Adjustment by X/Y or Color
Saturation submenus, and is most often needed with multiple-projector applications.
Select the color adjustment producing the best color accuracy for your application
and installation.
To configure a “User” color adjustment (gamut), use either the Color Adjustment by
X/Y or Color Saturation submenu.
NOTES: 1) “Color Temperature” defaults to 6500K until changed. All four “User”
options default to SD Video unless they have been redefined by the user. 2) Factory-
defined color primaries, which ensure consistent color gamut from projector-to-
projector, can be altered in the Service menu only. If you suspect alteration, the
factory settings can be recovered with selection of Reset to Factory Defaults? in the
Service menu (password-protected).
COLOR TEMPERATURE —
Adjust to apply a specific color temperature to all displays.
Color temperatures are expressed in degrees Kelvin (3200-9300K), and utilize
different combinations of the projector’s original native color primaries to produce a
“coloration” or cast (reddish or bluish) in images—the lower the temperature, the
more reddish the cast; the higher the temperature, the more bluish the cast. Note that
slidebar is enabled only if you have a source connected and have selected “Color
Temperature” in the adjacent “Select Color Adjustment” pull-down list in the
Advanced Image Settings menu.
RESERVED —
No function.