Christie Roadie 25K, Руководство пользователя

Страница: 115 / 191

OPERATION
Roadie 25K User’s Manual
3-59
as a rental period), and for your projector model name and serial number. In addition,
the Status menu identifies the current channel, its location, its frequencies and other
details.
Scroll the full Status menu using . Use for page up/down.
When an installation requires multiple projectors, you can use the RS232 and/or
RS422 serial ports to daisy-chain the units together and control the group with a
single keypad or a computer/controller connected to the first projector. In such a
network, you can choose to broadcast commands to the entire group, or use the
Proj
key as desired to limit responses to an individual projector. Or you may prefer that
each projector in an installation stands alone and responds only to a unique
transmission protocol from its own keypad (NOTE: alternative IR keypad protocols
are not supported in v1.1 software.)
Alternatively, you may want to add projectors to an Ethernet network.
NOTE: Refer back to 3.8, Adjusting System Parameters and Advanced Controls for
complete information about communicating with multiple projectors.
In a multiple-projector wall, you will likely want to precisely match color and intensity
from image-to-image so that the full wall is as uniform as possible. This matching is
typically done in conjunction with brightness uniformity and edge blending.
Preliminary Calibration
As a final part of the manufacturing process, all primary colors in the projector are
precisely set to pre-established values to ensure that overall color performance is
optimized and is as accurate as possible (refer back to Figure 3.23). Upon installation
at a site, however, lighting and other environmental factors may slightly change how
these colors appear on your screen. While the change is negligible in most cases, you
may prefer to recover the originally intended color performance before trying to
match colors from several projectors. Or you may be renting a projector in which the
colors were changed for use at its previous site, but are not ideal for yours.
The good first step in achieving such consistency is to use a color meter to measure
the native primary colors—red, green, blue, and white—as they appear at the screen
and record these as Color Primary Settings in the Service menu (password-protected)
for each projector. On the basis of these new values, which are stored in memory,
each projector will then automatically calculate any necessary corrections to
reproduce the original factory colors under the current environmental conditions.
This essentially calibrates a projector to its surroundings, compensating for factors
such as screen type, lamp and/or ambient lighting that can alter the final color
characteristics on-screen, and will improve color accuracy and consistency in a group
of projectors. It ensures a good starting point for further customizing and matching.
To return to the factory-set color primaries, such as when a projector is moved to
different site, you must access the Service menu (password-protected). Select the
Reset to Factory Defaults? option in the Color Primaries submenu. Then repeat the
calibration process describe above, if desired, and continue with matching of colors.
NOTE: Using the Service menu to set the projector’s primary colors as described
above is not a requirement for color matching, and is rarely necessary.
3.12 Using Multiple
Projectors
Matching Colors
'
In Multiple Screens