Christie Roadie 25K, Руководство пользователя

Страница: 44 / 191

INSTALLATION AND SETUP
2-38
Roadie 25K User’s Manual
working with a network of projectors linked via their RS232 in/out ports. In this case,
select “All Joined” for “Network Routing” in the Communications menu so that all
messages reach all ports throughout the network.
Figure 2.39. Joining All Networks
If desired, you can isolate your RS422 communications so that they are not relayed to
any other network—select the “RS232 and Ethernet joined” option for “Network
Routing” in the Communications menu. Messages from Ethernet will reach the
RS232 network, and vice versa, but RS422 messages will not.
Or, to isolate Ethernet select “RS232 and RS422 Joined”—all serial messages will be
relayed to all serial ports, but Ethernet communications will not (and vice versa).
To keep each communication link separate from the others, select “Separate”.
It is helpful to define a unique 3-digit projector number to each projector connected
in a serial network (for instance, 001, 002, 003, etc.). These numbers enable you to
direct commands to a single projector rather than always broadcasting to the entire
network. For complete information on how to assign and use projector numbers on a
serial network, see 3.8, Adjusting System Parameters and Advanced Controls.
Do not connect the ballast to AC unless the projection head and ballast are already
connected to each other, otherwise the exposed live ends of the heavy ballast cables
could be a serious hazard.
WARNING
Connect the ballast to the projector FIRST , then connect to AC.
Communicating to
'
Certain Ports
Projector Numbers
'
2.8 Connecting the
Ballast