Chicago Dryer Edge MAXX, Инструкция по эксплуатации

Страница: 167 / 288

Edge MAXX Repair
7-35
WARNING
Never turn on power while
pulling the ribbons through.
This is dangerous and
unnecessary.
Rotate each ribbon by hand to locate the
connection points between the cotton rib-
bon and the elastic insert.
Remove the connecting pin and attach one
end of the new elastic insert. Repeat for
the other end.
3.
4.
Transfer Conveyor Drive and Idler
Roll Tracking Tap Replacement
Tracking tape is used to hold transfer conveyor
ribbons in proper position during operation
to keep ribbons from moving laterally or
overlapping each other.
Tracking tape is positioned underneath the
center of each ribbon and wound around the
outside of both the drive and idler rolls.
Required Tools
pliers, permanent marker, scraper/
sandpaper/steel brush, soft cloth
Perform only when the unit is OFF
with power disconnected.
Make sure there is enough 1" (25 mm) tape
available to replace the old material. One
roll of tracking tape is required.
Turn power OFF at the main disconnect
switch.
Pull the ribbons around their tracks until
all the lacing clips are accessible and
aligned.
Remove the connecting pins from all the
ribbons and move them away from the
drive and idler rolls. It is not necessary to
remove them from the machine.
Remove the old tape from the drive roll
and idler rolls. Mark the center position of
each tape with a permanent marker so new
tapes can be properly positioned.
Scrape off any old cement which remains
on the roll using a scraper, coarse sand-
paper or a wire brush. Wipe away any
remaining residue with a clean cloth.
1.
2.
3.
4.
5.
6.
TOC INDEX