Edge Maxx
Troubleshooting
6-15
WARNING
Only trained personnel with experience
in electrical or mechanical repair should
troubleshoot and repair the unit.
Troubleshooting
WARNING
Read the
REPAIR
chapter and make
sure that the power is disconnected
before doing any repairs.
ISSUE
POSSIBLE CAUSE
SOLUTION
Neither Side of Clutch/Brake
Rollers Stop
1. Feeder is not ON.
Turn the feeder ON at the CHI panel.
Make sure no fault messages are
displayed.
•
2. Sensor problems.
Check. For more information within
this chapter, refer to
Sensor Function
section.
•
Clutch/Brake Rollers Stop
Late; Corners Dropped; Cor-
ner Size Inconsistent
1. Clutch rollers have string
and/or debris build up.
Check/clean. Refer to the
PREVEN-
TIVE MAINTENANCE
chapter,
Daily
PM
section,
General Cleanliness
procedure.
•
2. Sensor problems.
Check. For more information within
this chapter, refer to
Sensor Function
section.
•
3. Pneumatic clutch/brake
malfunction.
Check. Repair/replace as necessary.
•
4. Air valve malfunction.
Check. Repair/replace as necessary.
•
5. Air pressure is poor.
Make sure the incoming air pressure is
set to 80 psi (550 kPa).
•
6. There is a gap between
the clutch and brake roll-
ers.
Adjust so there is no gap between the
clutch and brake rollers. Refer to the
REPAIR
chapter,
Inlet Section
sec-
tion,
Pneumatic Clutch/Brake Roller
Alignment
procedure.
•
7. Low air pressure or slow
pressure restoration after
an air blast.
Adjust for steady air pressure at the
valve
•
8. Consistent symptoms may
be caused by a mis-ad-
justment of the corner
grab delay.
Adjust the GRAB delay. Refer to the
CHI PANEL OPERATION
bulletin,
Adjustment
section,
Program Adjust-
ments [PGM SPECIFIC]
procedure.
•
9. Clutch/brake arm is frozen
or binding.
Clean, lubricate, or replace.
•
Machine Stops
Message Reads:
CORNER CLUTCH JAMMED
SHUTDOWN BEFORE REMOV-
ING
1. Photosensor set PE1/2
(left station or PE13/14
(right station) is covered
too long.
Clear jam from clutch/brake area.
Clean photosensors if necessary.
•
•
TOC
INDEX
Содержание Edge MAXX
