CHART MVE 1842P-150, Руководство по эксплуатации и техническому обслуживанию

Страница: 124 / 161

MVE Biological Systems
TEC 3000 Operating and Maintenance Freezer Manual
13289499 Rev H •
123
MVE Cabinet Series
1. Remove lid from freezer hinges.
a. Place the lid in the closed position.
b. Remove spring pressure from the hinge by loosening the ½ inch nut on the rod
inside the hinge body.
c. Remove screws securing the hinges to the freezer lid.
2. Remove liner retainer plate from the back of the lid.
3. Slide the plastic liner and plate assembly out through the back of the lid.
4. Note how the current gasket is installed. The replacement gasket will be installed in the same
manner.
5. Separate the plastic liner from the plate.
6. Remove gasket.
7. Inspect plastic liner and Styrofoam cork for damage and replace if necessary.
8. Install new gasket in the same manner between the liner and plate.
9. Slide plastic liner and plate assembly back into the lid.
10. Cut a 6 inch (150 mm) gap in the gasket at the back of the lid to allow sufficient venting.
11. Reinstall lid hinges.
a. With the lid closed, install and tighten screws securing hinges to the lid
b. Using the ½ inch deep well socket, increase spring pressure until the hinges will
hold the lid at approximately a 45° angle.
Liner retainer plate
Lid cover
Lid lock
Lid gasket
Styrofoam cork Plastic liner