Ceyear 1465 Series, Руководство по программированию

Страница: 104 / 143

3 SCPI
3.3 Instrument subsystem command
97
-30
，
45
， 1‖
This example shows that the multi tone frequency interval is set to 1 MHz. There are
three tones. The first has an Atten Ampl of 10 dB and Phase of 90 degrees, in OFF
status; the second has an Atten Ampl of 20 dB and Phase of 0 degrees, in ON status;
the third has an Atten Ampl of 30 dB and Phase of 45 degrees, in ON status.
Reset status: 1MHz
，
2
，
0dB
，
0deg
，
1
Key Entry: None
Note: for setting only.
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe:FSPacing <FreqSpacing>
Function: This command sets Freq Interval, which takes effect only after Multi Tone is turned on.
For enabling or disabling the multitone modulation function, see the command
―
:RADio:MTONe:ARB:STATe
‖. For designating other parameters of multitone
modulation or setting the multitone list, see the command
―
:RADio:MTONe:ARB:SETup:TABLe
‖.
Setting format: [:SOURce]:RADio:MTONe:ARB:SETup:TABLe:FSPacing <val><freq unit>
Query format: [:SOURce]:RADio:MTONe:ARB:SETup:TABLe:FSPacing?
Parameter:
<FreqSpacing> Freq Interval.
Range: 1MHz[100Hz
，
200MHz].
Example: [:SOURce]:RADio:MTONe:ARB:SETup:TABLe:FSPacing 200kHz
Set frequency interval in multi tone table to 200 kHz.
Reset status: 1MHz
Key Entry:
【
Dual/Multi Tone
】 —>[Multi Tone]—>[Base Config]—>[Freq Interval]
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe:NTONes <NumTones>
Function: This command is used for setting the number of tone in the multitone modulation list.
This command is valid only when multitone modulation function is enabled. For
enabling or disabling the multitone modulation function, see the command
―
:RADio:MTONe:ARB:STATe
‖. For designating other parameters of multitone
modulation or setting the multitone list, see the command
―
:RADio:MTONe:ARB:SETup:TABLe
‖.
Setting format: [:SOURce]:RADio:MTONe:ARB:SETup:TABLe:NTONes <val>
Query format: [:SOURce]:RADio:MTONe:ARB:SETup:TABLe:NTONes?
Parameter:
NumTones> Number of tone in the multitone modulation list.
Range: 2[2
，
64].
Example: [:SOURce]:RADio:MTONe:ARB:SETup:TABLe:NOTNes 3
Set number of tone in multitone modulation list to 3.
Reset status: 2
Key Entry:
【
Dual/Multi Tone
】 —>[Multi Tone]—>[Base Config]—>[Tone Count]