Ceyear 1465 Series, Руководство по программированию

Страница: 103 / 143

3 SCPI
3.3 Instrument subsystem command
96
specifying an absolute path.
Setting format: [:SOURce]:RADio:MTONe:ARB:SETup <file_name>
Parameter:
<FileName> String type, multi tone file name.
Example:
[:SOURce]:RADio:MTONe:ARB:SETup ―mtone1.mtn‖
Load file mtone1.mtn to the memory of the signal generator.
Key Entry:
【
Dual/Multi Tone
】 —>[Multi Tone]—>[Base Config]—>[Load]
Note: for setting only.
[:SOURce]:RADio:MTONe:ARB:SETup:STORe <FileName>
Function: This command stores the waveform data in the current multi tone table to the multi tone
file of the signal generator. For command parameters, it is only necessary to set multi
tone file name without specifying an absolute path.
Setting format: [:SOURce]:RADio:MTONe:ARB:STORe <file_name>
Parameter:
<FileName> String type, multi tone file name.
Example: [:SOURce]:RA
Dio:MTONe:ARB:STORe ―mtone1.mtn‖
Save multi tone table to the signal generator multi tone file mtone1.mtn.
Key Entry:
【
Dual/Multi Tone
】 —>[Multi Tone]—>[Base Config]—>[Save]
Note: for setting only.
[:SOURce]:RADio:MTONe:ARB:SETup:TABLe
<FreqSpacing>,<NumTones>,<Pow>,<Phase>,<State>
Function: This command creates and configures a multi tone waveform. The command parameters
include: <freq_offset>, <num_tones>, <pow>, <phase> and <state>. <Freq_offset>,
this parameter is limited by 200 M baseband bandwidth and tone count in multi tone
table. Such value between tones is the same as frequency interval.
Setting format: [:SOURce]:RADio:MTONe:ARB:SETup:TABLe
<freq_spacing>,<num_tones>,{<pow>,<phase>,<state>…}
Parameter: String Type Parameter
<FreqSpacing> Freq Interval.
Range: 1MHz[100Hz
，
200MHz].
<NumTones> Tone Count
Range: 2[2
，
64].
<Pow> Atten Ampl
Range: 0dB[-100dB
，
0dB].
<Phase> Initial Phase.
Range: 0deg[0deg
，
359deg].
<State> Status. Boolean data is as follows:
1
：
ON,
0
：
off.
Example: [:SOURce]:RADio:MTONe:A
RB:SETup:TABLe ―1000000 ，
3
，
-10
，
90
，
0
，
-20
，
0
，
1
，