Canon CXDI-80C, Руководство по обслуживанию

Страница: 58 / 164

2. Installation procedures
- 25 -
1) Select [Service Tool] → [Connection] → [Detector], and then open the [Ferry Static Detector] screen.
2) Select the detector to be used by the wireless and wired connection.
3) From the [IP] tab, set [Use wired option] of [Wired] to ON, set the target IP address, and then register
the detector again.
• For details, refer to “Appendix6 AP/LINK Configuration Tool” in Chapter 4. Setting reference of
the CXDI Control Software NE V.1.40 Service Manual.
Note:
* Allocate different IP addresses when using both wireless and wired connections with one detector.
Example: Serial no. 19000001
IP address for wireless connection: 192.168.100.11 (assigned automatically)
IP address for wired connection: 192.168.100.12 (changed manually)
[Reference] The table below shows the status display patterns of the LED display provided on the
detector.
Category Item POWER READY LINK Remark
Blue Green Blue-green
Power-related statuses Power OFF
× （×） （×）
Power ON
○ － －
Remaining battery charge level 8 to 5%
(replace battery)
★ － －
Low remaining
battery charge
Remaining battery charge level 4 to 0%
(no imaging possible)
☆ － －
Battery error
Communication-related
statuses LAN LINK not completed
○/★/☆
※
1
－ ×
LAN LINK completed
*2
○/★/☆
※
1
－ ○
Line established
Imaging data transfer underway
○/★/☆
※
1
○/★ ★
Imaging data transfer error
*3
○/★/☆
※
1
☆ ☆
Maintenance-related statuses Software update underway or backup code
startup processing underway
（○） － ★
Software update error or backup code start
error
*3
（○） ☆ ☆
Indicated for
5 seconds
Infrared
communication-related
statuses Infrared communication underway
(detector registration underway)
○/★/☆
※
1
× ☆
Infrared communication completed
(detector registration completed
）
○/★/☆
※
1
○ ○
Indicated for
1 second
Infrared communication error
*3
○/★/☆ ※
1
☆ ☆
Indicated for
3 seconds
Operation-related statuses Startup error
*3
☆ ☆ ★
FPGA configuration error
*3
☆ ★ ☆
Other error
*3
☆ ☆ ☆
Detection status-related
statuses At startup
○ ○ ○
Indicated for
1 second
Initialization underway
○/★/☆
※
1
× －
Selection enabled
○/★/☆
※
1
× （○）
Selected status
○/★/☆
※
1
★ （○）
Sleep status
Imaging preparations underway
○/★ ※
1
☆ （○）
Imaging enabled and imaging underway
○/★
※
1
○ （○）
Ready status
○
: Lights,
×
: Off,
☆
: Blinks,
★
: Blinks slowly, –: Any status, ( ): Not controlled
*1
: Depending on the remaining battery charge, the LED concerned either “
★
” (blinks slowly) or
“
☆
” (blinks).
*2
: “LAN LINK completed” refers to the status in which the access point and the wireless
communication system or wired communication system are linked.
*3
: A mode in which two or more LEDs concerned “
☆
” (blink) indicates an error.