Canon ColorWave 3800, Руководство по эксплуатации

Страница: 28 / 358

Take-up module (TUM) / Roll Wind module
(RWM) Illustration
The take-up module and the Roll Wind mod-
ule enable you to wind up your print job on a
roll without cutting. This can be handy when
you want to transport your prints or want to
finish your prints at a later time. When your
machine is equipped with the take-up mod-
ule or the Roll Wind module, you must first
put the machine into the roll-to-roll mode.
You can enable the roll-to-roll mode in
WebTools Express and on the user panel.
NOTE
The take-up module and the Roll
Wind module are not supported in
combination with the [Receiving
rack (basket)], folding device or
Stacker Select.
See The take-up module (optional) and the
Roll Wind module (optional) on page 31 ,
Configure the roll-to-roll mode in WebTools
Express
on page 138 and Configure the roll-
to-roll mode
on page 31
Select the finishing device configuration
When to do
On the user panel, you can choose the type of the finishing device. The default value is [No
finisher].
Procedure
1.
Tap on the system menu thumbnail in the dynamic bar. The system menu opens.
2.
Tap on [Finishing device] in the list in the right part of the display.
3.
Log in as a Key operator.
A wizard opens.
4.
Follow the steps in the wizard.
Result
After you have followed the steps, restart the system to apply the configuration.
Select the finishing device configuration
28 Chapter 2 - Get to know the printing system