Brother S-7300A, Руководство по обслуживанию

Страница: 161 / 196

S-7300A
8. REPLACING PARTS
150
Lowest position of
needle bar
Raised 6 mm
<Thread trimming cam position adjustment>
1. Turn the machine pulley to raise the needle bar 6 mm
from its lowest position (reference line (a) position) so
that reference line (b) is aligned with the bottom edge of
the needle bar bush.
2. At the above position, push the plunger (1) of the thread
trimming solenoid with your finger in the direction of the
arrow.
Adjust the position of the thread trimmer cam (2) at this
time so that the roller shaft (4) of the thread trimming cam
lever assembly (3) touches the hollow (c) of the thread
trimmer cam (2) and so that the clearance between the
edge of the thread trimmer (2) and the roller (4) is 0.5 to
1.0 mm, and then tighten the set screw (5). (Fig. [A])
3. Check that the edge of the thread trimmer cam (2) and
the roller shaft (4) do not touch when the roller shaft (4)
returns to the right. (Fig. [B])
* Tighten the two set screws (5) to approximately 4 N.m.
Reference
line (a)
Direction of cam
rotation
0958D
1196D
Reference
line (b)
0.5mm
-
1.0mm
Should not touch