Brocade Communications Systems Network Advisor 12.0.0, Руководство пользователя

Страница: 499 / 1505

Brocade Network Advisor SAN User Manual 451
53-1002696-01
DCB Configuration
16
Editing a DCB port
1. Select Configure > DCB.
The DCB Configuration dialog box displays, showing the status of all DCB-related hardware and
functions.
2. Select a DCB port from the Products/Ports list.
3. Click Edit.
The Edit Port dialog box displays, as shown in Figure 155 .
FIGURE 155 Edit Port dialog box
4. Modify the following DCB port parameters as required:
•
Interface Mode - Select None or L2. For external ports, the L3 interface mode displays in
addition to None or L2. If you select L3 as the interface mode, the IP/Netmask field is
enabled and you can then assign the primary and secondary IP addresses.

L2 mode - The L2 mode is enabled if you select L2 as the interface mode. If a DCB
port is enabled on the 10 Gbps DCB/FC switch module, the L2 mode is disabled.

L3 mode appears only for the external ports of embedded platforms.
You can change the interface mode from L2 to None only if the port is assigned to the
default VLAN 1.
•
IP/Netmask - The netmask is used to divide an IP address into subnets. It specifies which
portion of the IP address represents the network and which portion represents the host,
and can only be configured if the interface mode is L3.

Primary - The primary IP address assigned to a 10 Gbps DCB/FC switch module.

Secondary - The secondary IP address is optional. Secondary IP addresses are helpful
when the interface port is part of multiple subnets.