Brocade Communications Systems Network Advisor 12.0.0, Руководство пользователя

Страница: 1008 / 1505

960 Brocade Network Advisor SAN User Manual
53-1002696-01
Adding a policy monitor
31
3. Enter a user-defined name for the policy in the Name field.
The name must be unique. It cannot be over 64 characters, nor can the field be empty. It
cannot include asterisks.
4. Enter a description of the policy in the Description field.
The description cannot be over 128 characters. It cannot include asterisks.
5. Click the Schedule Use check box and choose one of the following options:
•
To use the default frequency (one time, runs at current system time plus fifteen minutes),
go to
step 6 .
•
To configure the frequency, click the ellipsis button and choose one of the following
options to configure the frequency at which deployment runs for the policy monitor:

To configure deployment to run only once, refer to “Configuring a one-time policy
monitor schedule” on page 965.

To configure hourly deployment, refer to “Configuring an hourly policy monitor
schedule” on page 965.

To configure daily deployment, refer to “Configuring a daily policy monitor schedule”
on page 965.

To configure weekly deployment, refer to “Configuring a weekly policy monitor
schedule” on page 966.

To configure monthly deployment, refer to “Configuring a monthly policy monitor
schedule” on page 966.
6. To set policy monitors for fabrics, select the Fabric Checks tab and complete the following
steps.
a. Select the Check zoning status check box to determine if zoning is enabled or disabled on
the fabric.
•
Select the Enabled option to determine if zoning is enabled.
•
Select the Disabled option to determine if zoning is disabled.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 952.
b. Select the Check that all zones belong to at least one zone config check box to determine
if there are orphaned zones in the fabric zone database.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 952.
c. Select the Check the number of initiator ports zoned to each storage port check box to
determine the total number of initiator ports zoned to each storage port.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 952.
d. Enter the initiator port limit in the Initiator Port Limit field.
The default recommended threshold ratio is 20:1 (20 initiator ports to 1 target port).
Therefore, if the ratio for the storage port is equal to or higher than 20:1, the policy
monitor considers it as a violation and logs it in the report.