Bosch Rexroth IndraMotion MTX 11 VRS, Руководство по применению, Страница: 184 / 304

To improve clarity, the meaning can be written in front of each variable.
Sample entry of a parameter: Date of printing:#PRINT_DATE#
8.2.5 Tool Editors
Differences in Behavior Between Adding and Editing
Add a Tool In "Insert tool" the entire data set is first edited offline, i.e. without accessing
data on the control. Only after the data set has been edited completely is the
user requested to decide whether he wants to transfer it to the control system.
When a new tool data set is created, the tool catalog for the new tool can be
used to select a tool type from a list of predefined tool types. If a basis data set
for this tool type exists in the catalog, it is used to initialize the data set. Detailed
information can be found in the following section.
Edit a Tool In the case of "Edit tool", the modified data are immediately written to the tool
database of the control system. Therefore, there is no query as in Add.
Container Contents
As can be seen in fig. 8-2 " Container layout of the tool editor" on page 161 , the
tool editor is divided into a configurable number of display containers.
The number, arrangement, size and content of the containers can be config‐
ured; the content is defined using the assigned controls.
A separate F-key panel can be assigned to each control.
However, these panels cannot be edited in the F-key configurator; they can be
found in predefined F-key files.
Configuration can be carried out in IW Engineering.
Upon delivery the tool editor is configured as follows:
Container
No. in the fig‐
ure
Control Contents
1 Save basic Tool name
Duplo no.
T. No.
Tool technology
Tool type
Edge number
2 Bitmap and sector/location display Tool type as bitmap
Sector No.
Loc. No.
3 Location and tool status Tool status bits:
1;3;4;5;7;8;11;12;
User status bits:
25;26;27;28
Location status bit:
2
Bosch Rexroth AG DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation
182/301
Tool Management