BLEMO ER24 Series, Руководство по программированию

Страница: 36 / 344

38
Setup
Steps for setting-up the drive
INSTALLATION
1. Please refer to the installation manual.
PROGRAMMING
2. Apply input power to the drive, but do not give a run
command.
Tips:
•
Before beginning programming, com plete the cus tomer
s etting tables , page
321 .
•
Us e the
[Restore config.]
(FCS) param eter, page 81 , to
return to the factory s ettings at any tim e.
•
To locate the des cription of a function quickly, us e the index
of functions page
319 .
•
Before configuring a function, read carefully the "Function
com patibility" s ection page
165 .
Note : The following operations m ust be perform ed for
optim um drive perform ance in term s of accuracy and
res pons e tim e:
•
Enter the values indicated on the m otor rating plate in the
[MOTOR CONTROL]
(drC-) m enu, page 105 .
•
Perform auto-tuning with the m otor cold and connected
us ing the
[Auto-tuning]
(tUn) param eter, page 87 .
3. Configure:
•
The nom inal frequency of the m otor
[Standard mot. freq] (bFr) page 86 if this is not 50 Hz.
•
The m otor param eters in the
[MOTOR CONTROL]
(drC-)
m enu, page 105 , only if the factory configuration of the drive is
not s uitable.
•
The application functions in the
[INPUTS / OUTPUTS CFG] (I_ O-) m enu, page 125 , the
[COMMAND] (CtL-) m enu, page 154 , and the
[APPLICATION FUNCT.]
(FUn-) m enu, page 167 , only if the
factory configuration of the drive is not s uitable.
4. In the [SETTING S] (SEt-) menu, adjust
the following parameters:
•
[Acceleration]
(ACC) , page 87 and
[Deceleration]
(dEC) , page 87 .
•
[Low speed]
(LSP) , page 87 and
[High speed] (HSP) , page 89 .
•
[Mot. therm. current]
(ItH) , page 87 .
5. Start the drive.