BLEMO ER24 Series, Руководство по программированию

Страница: 224 / 344

Configuration Mode (ConF)
226
Operation with long cams:
In this ins tance, there is no res triction, which m eans that the function is initialized acros s the whole trajectory.
Forw ard slow dow n zone
Forw ard slow dow n
Forw ard stop zone
Forw ard stop
Stop at distance calculated after deceleration limit switch
This function can be us ed to control the s topping of the m oving part autom atically once a pres et dis tance has
been traveled after the s lowdown lim it switch.
On the bas is of the rated linear s peed and the s peed es tim ated by the drive when the s lowdown limit s witch
is tripped, the drive will induce the s top at the configured dis tance.
This function is us eful in applications where one m anual-reset overtravel lim it s witch is com m on to both
directions . It will then only res pond to help m anagem ent if the dis tance is exceeded. The s top lim it s witch
retains priority in res pect of the function.
The [Deceleration type] (dSF) param eter can be configured to obtain either of the functions des cribed
below:
Frequency
[Deceleration type]
(
dSF
) =
[Standard]
(
Std
)
Slow dow n
frequency
A B
Distance
A: Slow dow n limit sw itch reached
B: Automatic stop at a distance
Frequency
[Deceleration type]
(
dSF
) =
[Optimized]
(
OPt
)
Slow dow n
frequency
Note:
Distance
A
B
•
If the deceleration ram p is m odified while s topping at a dis tance is in progres s, this distance will not be
obs erved.
•
If the direction is m odified while s topping at a dis tance is in progress, this distance will not be obs erved.
WARNING
LOSS OF CONTROL
Verify that the configured distance is actually possible.
This function does not replace the limit switch.
Failure to follow these instructions can result in death, serious injury, or equipment damage.
[Stop distance]
(
Std
)