BLEMO ER24 Series, Руководство по программированию

Страница: 214 / 344

Configuration Mode (ConF)
216
Code Nam e / De s cription Adjus tment range Factory s e tting
FUn-
[APPLICATION FUNCT.] (continued)
tOL- [TORQUE LIMITATION]
tLA [Torque limit. activ.]
[No] (nO)
nO
If the assigned input or bit is at 0, the function is inactive.
If the assigned input or bit is at 1, the function is active.
[No] (nO) : Function inactive
[Ye s ]
(YES) : Function alw ays active
[LI1] (LI1) : Logical input LI1
[...] (...) : See the assignment conditions on page 153
YES
LI1
...
IntP [Torque increment]
[1%] (1)
*
This parameter cannot be accessed if [Torque lim it. activ.] (tLA) is set to [No] (nO) .
Selection of units for the
[M otoring torque lim ]
(tLIM) and
[Ge n. torque lim ]
(tLIG) parameters.
[0,1%]
(0.1) : Unit 0.1%
[1%] (1) : Unit 1%
0.1
1
tLIM [Motoring torque lim]
0 to 300% 100%
* This parameter cannot be accessed if [Torque lim it. activ.] (tLA) is set to [No] (nO) .
Torque limitation in motor mode, as a % or in 0.1% increments of the rated torque in accordance with the
[Torque incre m e nt ]
(IntP) paramet er.

(1)
tLIG [Gen. torque lim]
0 to 300% 100%
* This parameter cannot be accessed if [Torque lim it. activ.] (tLA) is set to [No] (nO) .
Torque limitation in generator mode, as a % or in 0.1% increments of the rated torque in accordance with the
[Torque incre m e nt ]
(IntP) paramet er.

(1)
tAA [Torque ref. assign.] [No]
(nO)
nO
If the function is assigned, the limitation varies betw een 0% and 300% of the rated torque on the basis of the 0% to 100% signal
applied to the assigned input.
Examples:
12 mA on a 4-20 mA input results in limitation to 150% of the rated torque.
2.5 V on a 10 V input results in 75% of the rated torque.
[No] (nO) : Not assigned (function inactive)
[AI1] (AI1) : Analog input
[AI2]
(AI2) : Analog input
[AI3] (AI3) : Analog input
[RP] (PI) : Pulse input
[AI Virtual 1] (AIU1) : Virtual analog input 1 w ith the jog dial
[AI Virtual 2] (AIU2) : Virtual input via communication bus, to be configured via [AI2 ne t. channe l] (AIC2) page 135 .
[OA01] (OA01) : Function blocks: Analog Output 01
...
[OA10] (OA10) : Function blocks: Analog Output 10
AI1
AI2
AI3
PI
AIU1
AIU2
OA01
...
OA10
Parameters described in this page can be accessed by:
DRI- > CONF > FULL > FUN- > TOL-