BelFox 47-21-i, Руководство по установке

Страница: 74 / 288

26
9.9. Light barrier
This menu item allows you to program the effect of the light barrier after
it has been activated:
NO Effect
OPEN Stop
OPEN Disengage (ca. 1 sec)
OPEN Reverse
CLOSE Stop
CLOSE Disengage (ca. 1 sec)
CLOSE Reverse
9.10. SE1 (closing)
In this menu item you can set whether the controller is to monitor the
safety input SE1 (terminal 32) for an 8.2kΩ resistor (safety contact strip)
or for an OES strip (optoelectronic safety contact strip).
8k2
OES
Furthermore, the effect of actuating the safety input must be selected
(only effective when closing!):
NO Effect
Stop
Disengage (ca. 1 sec)
Reverse
27
9.11. SE2 (Opening)
In this menu item you can set whether the controller is to monitor the
safety input SE2 (terminal 33) for an
8.2kΩ resistor (safety contact strip)
or for an OES strip (optoelectronic safety contact strip).
8k2
OES
Furthermore, the effect of actuating the safety input must be selected
(only effective when closing!):
NO Effect
Stop
Disengage (ca. 1 sec)
Reverse
9.12. SE-Standby
This menu item allows you to set whether the board cuts off the 12V
power supply of the optoelectronic safety edge (Terminals 31 & 34) at
gate standstill in order to save energy.
(This function is only necessary in battery mode):
NO Standby
Standby
9.13. Stop
This menu item is for informative purposes only(!), you can see whether
the stop is open < active> or closed <OK>.
9.14. Warning light
In this menu item, you can set whether and for how long the warning light
(terminals 7 & 8) lights up (0-10 seconds) before closing and before
Opening, except for setting end position indication.
Warning X-X Output „flashes“.
Warning XXX Output permanent signal.
End position Output is activated as soon as an end position is
reached.
End position
OPEN
Output activates as soon as an end position Open is
reached.
End position
CLOSED
Output activates as soon as an end position Closed is
reached.
It can be tested with the buttons<+> and <->.