BelFox 47-21-i, Руководство по установке

Страница: 73 / 288

ENG
LI
SH
24
To decide whether your gate system is DIN left or DIN right, please refer
to chapter 10 DIN LEFT & DIN RIGHT to find out which DIN your gate
system has.
NOTE: By changing the gate type, all menu configurations are set to the
default settings.
9.3. Radio
This menu option allows you to:
Program radio Program / teach-in new remote controls
Delete radio Delete individual or all remote-control codes
Radio level Displays strength of signal from remote controls &
displays active remote controls.
Amount acc. Displays the total number of remote controls
connected to the system
System Displays the programmed radio system (the radio
system of the first hand-held transmitter is taken
over)
9.4. Sensor
In this menu item, you can select which position detection devices are to
be used.:
Hall-sensors
Hall-sensors with reference switch
9.5. A Impulse
In this menu item you can determine the mode of action of input A:
Impulse (Open – Stop – Close – Stop …)
Limit switch (Limit switch OPEN with DIN-Left or limit switch CLOSE
with DIN-Right)
25
9.6. B Opening
In this menu item you can determine the mode of action of input B:
Stop panic (Open-Stop-…)
Stop no panic (Open-Open-…)
Deadman (Press-and-hold travel: the gate opens only as long as the
respective button is pressed)
Limit switch ((limit switch closed with DIN left or limit switch open
with DIN right)
9.7. C Closing
In this menu item you can determine the mode of action of input C:
Stop panic (Close-Stop-…)
Stop no panic (Close-Close-…)
Deadman (Press-and-hold travel: the gate closes only as the corre-
sponding button is pushed)
Limit switch (limit switch closed with DIN left or limit switch open
with DIN right)
9.8. D Partial-opening (PO)
In this menu item you can determine the mode of action of input D:
Stop panic (PO-Stop-Close-Stop…)
Stop no panic (PO-PO-…)
Auto closing OFF (Automatic closing turned off.)
Limit switch (Limit switch OPEN with DIN-left or limit switch CLOSED
with DIN-Right.)
Furthermore, the percentage of the partial opening’ travel distance (as
compared to the total travel distance) must be set here. It must be less
than 100%.
If input D is permanently activated and the gate is closed from end posi-
tion OPEN with automatic closing and no limit switch is set, the system
only closes up to the partial opening position (personnel entrance).