BelFox 47-21-i, Руководство по установке

Страница: 86 / 288

38
CAUTION!
During all learning trips, the gate must not be stopped by light barriers, safety
contact strips or anything else or prevented from running
normally.
Press the
"Escape/Menu" key repeatedly until the display shows "Learning
runs". Confirm this with the " / Return" key.
Press and hold the
"↑ +" or "↓ -." key accordingly to move the gate to the
OPEN position with the dead man function; you can also interrupt the move-
ment several times by releasing the key. When you have reached the end posi-
tion OPEN, confirm this with
" / Return". Make sure that the gate is not posi-
tioned in the mechanical stop.
The display shows
"Ref. run CLOSE", confirm this with " / Return". Now the
control unit closes the gate on its own up to the closing point, which is detect-
ed by the force switch-off.
You can also optionally stop the gate with the keys "↑+" or "↓-" before the
final closing point and then move it back manually to the closing position with
the keys "↑+" and "↓-".
When the closing position is reached, whether automatically or manually, con-
firm this with the
" / Return" key. Make sure that the gate is not positioned
in the mechanical stop.
Now the display shows "Learning run open?", confirm this with the
" / Return" button. The gate will start in the opening direction and automat-
ically learn the force values in the opening direction.
Then the display shows "Learning run close?", confirm this with the
" / Return" button. The gate will start in the closing direction and automati-
cally learn the force values in the closing direction.
Now the display shows "Learning runs OK?” If all learning trips were in order,
confirm this display with the " / Return" key.
If one of the learning trips has been influenced by an irregular procedure (safe-
ty device, etc.) select the answer option →No← with the key
"↑ +", confirm this with " / Return" and carry out the steps from "11.2."
again.
39
1122.. TTeeaacchhiinngg--iinn ooff tthhee rraaddiioo ccooddeess
NOTE: If one of the two systems (12-bit or 18-bit) has been programmed in a
system, only radio transmitters with the same bit system can be taught in. To
change the system, you must delete all the taught-in radio transmitters.
12.1. Programming
Press the
"Escape/Menu" key repeatedly until the display shows "Radio lev-
el:". Confirm with the " / Return" key.
Now the display shows "Learn radio?", confirm this with the
" / Return" key.
Now use the "↑ +" and "↓ -" buttons to select the desired radio function (see
list below) and confirm with
" / Return".
Radio functions: F1: Impulse (Open-Stop-Close-Stop-…)
F2: Open with stop (Open-Stop-…)
F3: Close with Stop (Close-Stop-…)
F4: Stop
F5: Partial opening (Personnel gateway, see menu
item 9.8-p.23)
F6: Open without stop (Open-Open-…)
F7: Close without stop (Close-Close-…)
F8: Light (switches on the light relay)
Now press the desired remote control button permanently until the
second line of the display reads "Detected: °SPXX°FY" lights up. The hand-held
transmitter key is now taught-in.
If only the display "Detected:" appears, the remote control key has not been
programmed.
12.2. Delete
You can delete all or only individual remote controls.
Press the "Escape/Menu" key repeatedly until the display shows "Radio level”.
Confirm with the " / Return" button.
Now use the "↑ +" and "↓ -" keys to select the desired "Delete radio?" func-
tion and confirm with
" / Return".