BelFox 47-21-i, Руководство по установке

Страница: 87 / 288

ENG
LI
SH
38
CAUTION!
During all learning trips, the gate must not be stopped by light barriers, safety
contact strips or anything else or prevented from running
normally.
Press the
"Escape/Menu" key repeatedly until the display shows "Learning
runs". Confirm this with the " / Return" key.
Press and hold the
"↑ +" or "↓ -." key accordingly to move the gate to the
OPEN position with the dead man function; you can also interrupt the move-
ment several times by releasing the key. When you have reached the end posi-
tion OPEN, confirm this with
" / Return". Make sure that the gate is not posi-
tioned in the mechanical stop.
The display shows
"Ref. run CLOSE", confirm this with " / Return". Now the
control unit closes the gate on its own up to the closing point, which is detect-
ed by the force switch-off.
You can also optionally stop the gate with the keys "↑+" or "↓-" before the
final closing point and then move it back manually to the closing position with
the keys "↑+" and "↓-".
When the closing position is reached, whether automatically or manually, con-
firm this with the
" / Return" key. Make sure that the gate is not positioned
in the mechanical stop.
Now the display shows "Learning run open?", confirm this with the
" / Return" button. The gate will start in the opening direction and automat-
ically learn the force values in the opening direction.
Then the display shows "Learning run close?", confirm this with the
" / Return" button. The gate will start in the closing direction and automati-
cally learn the force values in the closing direction.
Now the display shows "Learning runs OK?” If all learning trips were in order,
confirm this display with the " / Return" key.
If one of the learning trips has been influenced by an irregular procedure (safe-
ty device, etc.) select the answer option →No← with the key
"↑ +", confirm this with " / Return" and carry out the steps from "11.2."
again.
39
1122.. TTeeaacchhiinngg--iinn ooff tthhee rraaddiioo ccooddeess
NOTE: If one of the two systems (12-bit or 18-bit) has been programmed in a
system, only radio transmitters with the same bit system can be taught in. To
change the system, you must delete all the taught-in radio transmitters.
12.1. Programming
Press the
"Escape/Menu" key repeatedly until the display shows "Radio lev-
el:". Confirm with the " / Return" key.
Now the display shows "Learn radio?", confirm this with the
" / Return" key.
Now use the "↑ +" and "↓ -" buttons to select the desired radio function (see
list below) and confirm with
" / Return".
Radio functions: F1: Impulse (Open-Stop-Close-Stop-…)
F2: Open with stop (Open-Stop-…)
F3: Close with Stop (Close-Stop-…)
F4: Stop
F5: Partial opening (Personnel gateway, see menu
item 9.8-p.23)
F6: Open without stop (Open-Open-…)
F7: Close without stop (Close-Close-…)
F8: Light (switches on the light relay)
Now press the desired remote control button permanently until the
second line of the display reads "Detected: °SPXX°FY" lights up. The hand-held
transmitter key is now taught-in.
If only the display "Detected:" appears, the remote control key has not been
programmed.
12.2. Delete
You can delete all or only individual remote controls.
Press the "Escape/Menu" key repeatedly until the display shows "Radio level”.
Confirm with the " / Return" button.
Now use the "↑ +" and "↓ -" keys to select the desired "Delete radio?" func-
tion and confirm with
" / Return".