BelFox 47-21-i, Руководство по установке

Страница: 76 / 288

28
9.15. Light
In this menu item, you can set whether and for how long the light (termi-
nals 5 & 6) will be illuminated after the motor has run. The afterglow du-
ration can be set from 0-99 seconds in increments of seconds, then from
2-10 minutes in increments of minutes.
After glow 0sec-10min (Continue pressing the <+> key for further
settings.)
End position Output activates as soon as an end position is reached.
End position
Open
Output activates as soon as the end position Open is
reached.
End position
Closed
Output activates as soon as the end position Closed is
reached.
The light is always on when the motor is operating, except when setting
the end position.
It can be tested with the buttons<+> and <->.
9.16. Automatic closing
In this menu item you can set whether and after what time an automatic
closing starts. The duration until automatic closing (AC) can be set from
0-99 seconds in increments of seconds, then from 2-10 minutes in
increments of minutes. Furthermore, the time until automatic closing can
be set from 0 to 20 seconds after the light barrier has been released. If a
time is entered here, the control always tries to close the gate, when the
light barrier is left.
Note: Automatic closing can be switched on and off via input D (input D:
Auto Close OFF).
29
9.17. Current stop OPEN
CAUTION
Forces must be maintained!
Forces must not be set randomly. Failure to do so may result in serious injury
and/or damage to property.
SAFETY INSTRUCTION FOR HAZARD AVOIDANCE
Make sure that you comply with the applicable standards and forces.
Use any additional safety devices.
In this menu item you can set the current stop in the open direction (force
cut-off used for obstacle detection). You can:
switch this <active> or <inactive>,
select the start-up time, in which it is switched off,
set an addition value, which is applied to the taught-in values.
9.18. Current stop CLOSED:
CAUTION
Forces must be maintained!
Forces must not be set randomly. Failure to do so may result in serious injury
and/or damage to property.
SAFETY INSTRUCTION FOR HAZARD AVOIDANCE
Make sure that you comply with the applicable standards and forces.
Use any additional safety devices.
In this menu item you can set the current stop in the closed direction
(force cut-off, which serves to detect obstacles). You can:
switch this <active> or <inactive>,
select the start-up time, in which it is switched off,
set an addition value, which is applied to the taught-in values.